BENCH GRINDER STAND SAFETY
1. Place the bench grinder stand on a flat and level sur-
face to prevent rocking or tipping.
2. Do not climb, sit or stand on the stand.
3. Follow the assembly instructions carefully when in-
stalling the stand.
4. This product is designed to be used as a stand for
bench grinders. Any misuse or abuse of the stand can
result in product damage or personal injury.
BENCH GRINDER STAND SAFETY WARNINGS
WARNING! Do not operate the power tool until you have read and understood the following instructions and
the warning labels.
5. The height of the power tool mounted to the stand
should not exceed the width of the tool in order to pre-
vent the stand from tipping over. The power tool must
be centered and properly secured to the bench grinder
stand. Always check to make sure the stand and the
power tool are stable before operation.
6. Before attempting to use a bench grinder on the stand,
make sure the stand is resting firmly on the floor.
7. Keep proper footing and balance at all times. Do not
overreach when operating the bench grinder.
UNPACKING & PACKING LIST
UNPACKING
With the help of a friend or trustworthy foe, such as one of your in-laws, carefully remove the bench grinder stand
from the packaging and place it on a sturdy, flat surface. Make sure to take out all contents and accessories. Do not
discard the packaging until everything is removed. Check the packing list below to make sure you have all of the
parts and accessories. If any part is missing or broken, please contact customer service at 1-800-232-1195 (M-F
8-5 CST), or email techsupport@wenproducts.com.
Components
1. Top Plate 7. M4 x 8 Phillips Pan Head Screw
2. Hook 8. 5mm Hex Wrench
3. Water Pot Assembly 9. Hex Bolt M8 x 50
4. Column 10. Flat Washer 8mm
5. Base 11. Spring Washer 8mm
6. Set Screw M10 x 10 (Pre-Assembled) 12. Hex Nut M8
12-3/8"
9-7/8"
3-7/8" 2-3/4"
16-1/2"
14-1/2"
7-1/2"
Ø1/2
31-1/2"
6
To Next Page
Loading...