5. The belt can now be removed from the lower, vibrating assembly pulley (within the plate).
6. Remove the 4 nuts and washers from both sides of the engine support plate (Fig. 6).
7. Gently lift the handles, engine assembly, and support plate off the shock absorbers, and carefully set the
assembly to the side.
8. Remove the 8 mounting bolts from the exciter seat (Fig. 7), then remove the exciter seat and vibrating
assembly from the bottom plate. You may need an impact wrench or breaker bar to remove the bolts.
Date last modified: 2023/01/30
Fig. 7: Remove the 8 mounting bolts, then gently remove the exciter seat and vibrating
assembly from the bottom plate.
Fig. 6: Remove these nuts and washers (2 each side).
To Next Page
Loading...