MAINTENANCE
WARNING! Disconnect tool from air supply and empty fasteners from the magazine before performing any
cleaning or maintenance.
LUBRICATION
Routine lubrication of the tool is required for best performance. If the tool is used without an in-line oiler, place 3 – 4
drops of pneumatic tool oil into the air inlet of the tool at the beginning of each workday. This will ensure the moving
components, seals, and O-rings are properly lubricated.
COMPRESSOR
Follow the maintenance schedule recommended in your air compressor’s owner’s manual. Regularly check the air
filter and drain the tank at least weekly. This will help keep water and other contaminants from entering your nailer.
CLEANING
Keep tools clean for better and safer performance. Wipe the tool clean with a damp towel and mild soap. Blow the
tool clean using compressed air, then use non-flammable cleaning solutions to wipe exterior of the tool as neces-
sary. Do not soak tool with cleaning solutions. Such solutions can damage internal parts.
INSPECTION
1. Inspect trigger to assure system is complete and functional (no loose or missing parts, no binding or sticking
parts). Do not operate if any portion of the tool or trigger is damaged, inoperable, disconnected, or altered. Leak-
ing air, damaged parts, or missing parts should be repaired or replaced before use.
2. Keep all screws tight. Loose screws can cause personal injury or damage the tool.
3. Dirt, water, and other contaminants in the air supply are major causes of pneumatic tool wear. Follow the com-
pressor instructions to check the compressor’s air filter and to drain the compressor’s tank regularly.
STORAGE
Store the unit and accessories in a dark, dry, frost-free and well ventilated place, out of the reach of children. The
ideal storage temperature is between 50 to 86 °F (10 and 30 °C).
PRODUCT DISPOSAL
Used pneumatic tools contain recyclable materials and should not be disposed with household waste. Please take
this product to your local recycling facility for responsible disposal and to minimize its environmental impact.
11
To Next Page
Loading...
