15
ASSEMBLY & ADJUSTMENTS
CUTTING WITH A TEMPLATE
The plastic base cover of the straight base is designed to fit standard 1-3/16” template guides. Template guides can
be used to accurately duplicate curves and other shapes.
1. Remove the straight base from the trim router.
2. Select a template guide bushing with your desired diameter for your workpiece. Make sure that the inner diam-
eter of your template guide bushing is larger than the router bit.
3. Insert the threaded end of a template guide bushing into the bottom of the straight base. Place a template guide
nut inside the straight base and tighten the template nut onto the protruding threads of the guide bushing.
4. Re-install the straight base onto the router.
CUTTING ALONG A STRAIGHT EDGE WITH A TEMPLATE
A template can be created with a jigsaw (or any wood saw capable
of cutting a detailed outline) to guide the trim router using a tem-
plate guide bushing. When creating a template, account for the
cutting distance between the cutting edge of the bit and the outer
edge of the template bushing.
Fig. 9
Fig. 10
NOTE: Your WEN Trim Router is compatible with most router tables on the market. Check the router table dimen-
sions against the base diagram in Figure 10 above to confirm compatibility.
To Next Page
Loading...
Need help?
General