2120
Watch with Alarm
1. Begin by setting the regular time by following
the instructions on pages 6 and 7.
2. Pull crown out to Position 2.
3. Rotate crown clockwise to set alarm hand
(indicated in red) at desired alarm time.
4. Pull out alarm button (located at either 2 o’clock
or 11 o’clock) to set alarm. You will hear a brief
signal acknowledging that the alarm is set.
5. Return crown (not the alarm button) to Position 1. Alarm will sound when
hour hand passes alarm hand.
Note: Do not expose watch to moisture when alarm button is pulled out. Push
in alarm button to stop alarm at any time. If alarm button is not pushed in,
alarm will sound once, pause and then sound ten times and stop. Push alarm
button in to stop or alarm will sound again in 12 hours.
Dual Time Zone Feature
(2nd Time Zone Dual Sub-Dial, see page 12)
Note: The second time zone is read in military time
(1:00 p.m. = “13”, 2:00 p.m. = “14”, etc.). The
military time hours appear either on the dial, or
on some models, on the bezel of the watch.
1. Begin by setting the regular time by following
the instructions on pages 6 and 7.
2. To set the second time zone, pull out the crown to Position 2 (one “click”
out) and set the second time zone hand (indicated above in red) by turning
the crown clockwise.
3. Return the crown to the fully depressed Position 1, assuring the crown has
been screwed down on all 200m watches.
To Next Page
Loading...
Need help?
General
