EasyManuals Logo

Wenger Clock User Manual

Default Icon
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
3. For a watch with day and date display, pull out the crown of the watch to
Position 2, turn it clockwise to change the day and counterclockwise to
change the date.
4. Return the crown to the fully depressed Position 1, assuring the crown has
been further screwed down on all 200m watches.
Stopped Automatic Watches
If the watch is not worn it will wind down and stop. We suggest the following
procedure to start an automatic watch which has stopped. With the crown in
Position 1, wind the crown clockwise for approximately 30 seconds, and the
watch will start.
9
Setting the Time and Date on Automatic Watches
(see Table of Contents on p.1 for other watches)
1. Pull out the crown to Position 2 (one “click” out). Rotate crown clockwise
until the date shows one day earlier than the date you want to set.
2. Pull out the crown to Position 3 (two “clicks” out). Rotate crown so the watch
hands move clockwise until the current date shows. Then set the watch
hands to the correct time. Turn the watch hands past 12 once if you’re set-
ting the watch for a P.M. time. Push the crown back to Position 1.
(continued next page)
8
Position 1 Position 2 Position 3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wenger Clock and is the answer not in the manual?

Wenger Clock Specifications

General IconGeneral
BrandWenger
ModelClock
CategoryWatch
LanguageEnglish

Related product manuals