Need help?Do you have a question about the Wensar MAB 201 and is the answer not in the manual?
Intended to determine weighing value of material manually placed on the plate.
Instructions on what not to do with the balance to avoid damage or incorrect results.
Guidelines for selecting a stable, level location free from interference for accurate results.
Steps to carefully unpack and set up the balance at the workstation.
Ensure balance reaches operating temperature (1 hour warm-up) before initial use.
Coordinate balance to local gravity for accuracy; recommended after location change or temperature fluctuations.
Procedures for internal and external calibration to ensure measurement accuracy.
Using the TARE function to zero the display with a container or zero out unwanted weight.
Procedure for performing calibration using an external standard weight.
Adjusting sensitivity and stability using filter values for different usage scenarios.
To Next Page
General