6
1.
Identify the Front Stabilizer (10), which is
shorter than the Rear Stabilizer (not shown).
While a second person lifts the front of the
Frame (1), attach the Front Stabilizer (10) to the
Frame with two M10 x 75mm Carriage Bolts
(34) and two M10 Locknuts (33).
10
33
34
1
1
2. While a second person lifts the rear of the
Frame (1), attach the Rear Stabilizer (28) to the
Frame with two M10 x 75mm Carriage Bolts
(34) and two M10 Locknuts (33).
34
28
1
33
33
33
3. The Console (23) requires four AA batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents. Remove the screw, remove the battery
cover, and insert the batteries into the battery
compartment. Make sure to orient the batter-
ies as shown by the diagram inside the
battery compartment. Then, reattach the bat-
tery cover.
3
23
Batteries
Screw
Battery
Cover
To make assembly easier, read the
information on page 5 before you begin.
2
To Next Page
Loading...
Need help?
General
