Why does my Wessex CRX150 have excessive vibration?
Excessive vibration in your Wessex Lawn Mower can stem from several causes. First, check for damaged or missing blades and replace them if needed. Another potential cause is a failed main spindle bearing, which should be inspected and replaced if damaged. Lastly, ensure all nuts and bolts are tight, as a loose part can also cause vibration.
What to do if my Wessex CRX150 Lawn Mower has a bad quality of cut?
If your Wessex Lawn Mower isn't cutting properly, several factors could be the cause. Begin by reducing your forward speed. Check the blades for excessive wear and replace them if necessary. Also, inspect the belts and tighten them if they are slipping.
Why does my Wessex CRX150 Lawn Mower leave wheel track uncut?
If your Wessex Lawn Mower is leaving wheel tracks uncut, it could be due to a couple of reasons. The forward speed might be too fast, so try reducing it. Alternatively, the cutting height may be too high; lower it to see if that resolves the issue.
What to do if my Wessex CRX150 has excessive scalping?
If your Wessex Lawn Mower is scalping, the cutting height might be too low. Try raising the cutting height.
What to do if my Wessex CRX150 leaves a narrow strip uncut?
If your Wessex Lawn Mower is leaving a narrow strip uncut, it's possibly due to a missing or broken blade. Inspect the blades and replace them as necessary.
Essential warnings for operating the mower safely, including standstill, guards, and bystanders.
Key guidelines for the correct and safe use of PTO drive shafts.
Step-by-step guide on how to connect the PTO shaft to the tractor.
General| Brand | Wessex |
|---|---|
| Model | CRX150 |
| Category | Lawn Mower |
| Language | English |
To Next Page
