. FIELD USE
The TransCube is designed to efficiently and ef-
fectively transfer, transport and refuel equipment
in any location. It meets and exceeds all Cana-
dian and U.S. DOT fuel transporting requirements
and has UN certification. These IBC’s are built to
U.S. Standard Code of Federal Regulations (CFR)
part 49 and are updated by annual tests. Max in
USA 793 gallons.
Each owner and user of the TransCube should
review this manual as part of the regular training
and review procedure. Follow all instructions.
1. Owner Operator Responsibility
It is the responsibility of each owner, operator
or user to be familiar with all regulations that
apply to the equipment for transporting, filling,
transferring and refueling equipment. Perform
all tests per the regulations and maintain the
appropriate records and paperwork. Always
carry the required paperwork for the Transport
of Dangerous Goods. Be sure everyone is
properly trained and licensed to use or trans-
port the TransCube. Do not smoke around
unit. Do not allow others to smoke around
unit.
OPERATING SAFETY
Please remember it is important that you
read and heed the safety signs on the Tran-
sCube. Clean or replace all safety signs if
they cannot be clearly read and understood.
They are there for your safety, as well as the
safety of others. The safe use of this tank is
strictly up to you, the operator.
Use only for the transport of diesel fuel for
refueling equipment or stand-by generators.
Keep the tank level when filling.
Fill only with a hand-held trigger nozzle.
Do not spill fuel on the ground or in the tank.
Do not smoke when refueling. Keep sparks,
flames and hot material away from fuel and
TransCube.
Do not over fill. 95% is the maximum legal
limit.
Always replace filler cap and turn pump off
(lever down) when refueling finished.
Store diesel hose and nozzle inside outer
tank.
Close all valve outlets and lock lid when
transporting on public highway.
Follow the regulations of the Transport of
Dangerous Goods.
Check for fluid in outer tank and empty
regularly - refer to maintenance manual for
detailed procedure.
To Next Page
Loading...
Need help?
General