Fi . INTERSTICE
If severe sludge or trash formed in the
interstice, it is recommended that the
inner tank be removed and the outer
tank be completely washed out. Do
not take chances with contaminating
the workplace or the environment.
d. Monthly
ubricate the door hinge and lock.
Clean out pump and line filters includ-
ing strainer.
Visually check tank, hoses, valves,
pump and other components for
cracks, corrosion and leakage.
Correct all deficiencies before start-
ing. Stop leaks. Make repairs using
only genuine replacement parts or
their equivalent.
e. Compulsory 0 Month Testin at a
Re istered Facility
The Transport of Dangerous Goods
requires I C's to be leak proof tested
and inspected internally and externally
at a Government Registered Facility with
the results being recorded on the Record
Card and the date stamped on the Speci-
fication Plate.
c. Wee ly and efore
Transportin
Visually check
the interstice
bund to verify
that there have
been no leaks
from the primary
tank or any spills
during fuel trans-
fers. If it has any
sludge or liquid in
it, hand pump it
into an approved
container, seal
it and dispose
of it in accord-
ance with local
regulations. Do
not pour on the
ground or put in
drains.
. Preparation for 0 Month Testin
Cleaning - prior to being leak tested or in-
spected, the I C shall be
a. Thoroughly drained of all previous lad-
ings.
b. Interior washed to remove previous lad-
ings.
c. Interior rinsed to remove washing materi-
als.
d. Interior dried to remove liquids.
e. Exterior washed to remove previous lad-
ings, foreign material, labels and adhe-
sives from all exterior components of the
IC.
The TransCube is manufactured so that it
is easy to dismantle for cleaning, servicing,
repairs, inspections, etc.. Empty the tank, and
follow instructions outlined on the following
page.
To Next Page
Loading...
Need help?
General