W2069 WSW PRIME RANGE Built-in Unit O&M 20231025.docx Page 7 Westin
7. MAINTENANCE
Regular maintenance is essential to ensure good performance
and long-life.
To maintain the immaculate appearance of the extractor, and
to minimise fire risk, ensure that grease deposits on the
extractor surfaces are kept to a minimum by regular cleaning.
To clean the stainless-steel surfaces of the extractor, use a soft
cloth and a suitable cleaning agent, such as a specially
produced stainless-steel cleaner, or washing up detergent and
warm water.
Painted surfaces should be cleaned using a soft cloth,
detergent and warm water.
Glass surfaces should be cleaned with a suitable glass cleaning
agent.
• Do not use bleach-based cleaning products or
abrasive materials.
Clean the grease filters in a dishwasher or by hand-washing in
hot water and detergent every 2 months - sooner if the extractor
is used extensively and filters become grease laden.
• Whilst you can expect years of service from mesh grease
filters, they are considered a consumable item and may
deteriorate over time and need replacement, particularly
when cleaned in a dishwasher. For dishwasher users
adhering to a 2-monthly cleaning interval, we recommend
grease filter replacement every 5 years to maintain optimum
performance, even if they show no visible signs of
deterioration. For all users, filters should be replaced
whenever they exhibit signs of physical wear.
Removing the Grease Filters
The clip-in grease filters have an integrated sprung latch
mechanism. Release the latch by pulling the lever and remove
the filter.
Filters are replaced by locating the tabs opposite the lever into
corresponding slots in the extractor base and then pushing the
filter into position with the latch held open. Once the filter is in
position release the lever, allowing the latch to engage.
Lamp replacement
The long-life LED units are not designed for end user
replacement. In the unlikely event of failure please call Westin.
To Next Page
Loading...