Wever & Ducre Box User Manual

WEVER & DUCRÉ BVBA
Spinnerijstraat 99/21, 8500 Kortrijk, Belgium
weverducre.com
INSTALLATION INSTRUCTIONS | MARCH 2022
BOX
PB19-010-476-00_v2
1
press
The beam angle is adjustable.
Before adjusting the flaps, the cover must be mounted.
Installation method of INTERIOR / EXTERIOR
DIMENSIONS
100
00
1
100
1.0 / 2.0 LED
INTERIOR / EXTERIOR
3.0 / 4.0 LED
INTERIOR / EXTERIOR
100
100
160
86
74
Ø 5
74
62
37
6
6
base dimensions
2630
use pin to
make hole,
not a knife
TYPE
OUTSIDE Ø
CONDUCTION
SECTION
CABLE
min 1.5mm
max 2.6mm
C
ROUND
1.5mm
2
0.75mm
2
A
min 6.8mm
max 8.9mm
2or3x 0.75mm
2
2or3x 1.0mm
2
2or3x 1.5mm
2
ROUND
H05RN-F
H07RN8-F
H07RN-F
B
ROUND
H05RN-F
2or3x 0.75mm
2
2x 1.0mm
2
min 5mm
max 6.8mm
Remove the mounting base from the LED inset by loosening the side socket screws
and mount it on the wall with screws (screws are not included).
1
Fix the LED inset on the base with the side socket screws.
3
Fix the cover to the LED inset by pushing so the ball catch system will fix
in the slots.
4
POWER CONNECTION
2
Connect to 220-240V.
Connect the earth cable.
MOUNTING INSTRUCTION
mounting base
earthing
Push the grommet
into the back plate.
Pull the cable through
the back plate.
Mount the back plate
on the wall.
Please use a matching grommet based on the used 220-240V cable
and the corresponding type in the overview table.
for example:
1
3
4
2
adjustable flap
cover

Wever & Ducre Box Specifications

General

Brand	Wever & Ducre
Model	Box
Category	Outdoor Light
Language	English