Need help?Do you have a question about the Whale Dry-Deck 20 SDP073R and is the answer not in the manual?
General| Brand | Whale |
|---|---|
| Model | Dry-Deck 20 SDP073R |
| Category | Plumbing Product |
| Language | English |
Instructions for using larger pipe with gravity fall for horizontal waste pipe runs to increase pump life.
Guidance on positioning the control unit in accordance with electrical safety regulations (BS7671).
Wiring instructions for connecting flow sensors to the control box, specifying wire colours and terminals.
Instructions for connecting the pump's power wires to the control box, noting colour codes.
Guide on navigating menus and using buttons to adjust system settings on the control unit display.
Setting the display language for the control unit.
Selecting the correct type of flow sensor installed in the system.
Adjusting pump speed based on shower flow rate for optimal performance and noise reduction.
Fine-tuning pump speed adjustments for improved water level management in the shower gulley.
Configuring the pump's automatic shut-off mechanism based on water removal or time delay.
Setting a fixed time delay for the pump to continue running after the shower is turned off.
Defining the initial water volume in the tray required to activate the pump.
Enabling or disabling an automatic low-speed pump cycle to clear residual water from the gulley.
Setting the duration the pump remains in standby mode after operation.
Specifying the diameter of the inlet pipe for the Dry-Deck system.
Selecting the type of flow sensor connected to the control unit for accurate readings.
Viewing the system type and current software version of the control unit.
Displaying the total operating time of the pump.
Connecting a switch and transformer to control water shut-off to the shower for a set period.
Manufacturer's statement of compliance with relevant EC Directives for electromagnetic compatibility and low voltage.
Details the protection requirements met from EMC and Low Voltage Directives.
Lists the specific EN standards used to declare conformity for safety and compatibility.
To Next Page
