3
NOTICE
This temperature / pressure valve may weep during initial operation. This is normal. The
valve will seat itself with use. A drain hose should be installed at this valve and directed
overboard.
If the boat is connected to the dockside water system, make sure to turn off the system
at the dock when not attended. Also make sure a pressure regulator is used to control
pressure.
OPERATING INSTRUCTIONS
1. Fill water system and completely ll tank.
2. Locate and turn remote electrical switch to "ON".
3. Turn switch to "OFF" position prior to draining water system.
4. The temperature / pressure valve may weep during initial operation. This is normal.
The valve will seat itself with use.
NOTE:
DO NOT OPERATE HEATER WITHOUT ELEMENT BEING SUBMERGED IN WATER
MAINTENANCE
1. Check heat exchanger lines for leaks at regular intervals. A leak in the system will
cause coolant loss and may damage engine.
2. Flush tank periodically to help prevent build-up of deposits.
3. Protect against damage from freezing temperatures (32° F or less)
Please review the following:
a) Drain tank by fully opening drain valve. Open T&P valve to help relieve vacuum
in tank. (See item 2 in exploded view)
b) It is recommended you winterize your fresh water system. First complete step
3a, then follow instructions of your local supplier regarding chemicals to use
and how to use them.
CAUTION
If heater has been run without water and now fails to work, ll heater tank with water and push
electric reset button high limit switch under wire access cover before calling for service.
To Next Page
Loading...
Need help?
General
