Important Information
Please read the following information before setting up a Bluetooth
®
wireless technology connection between
the Whale Instant
®
Match with Bluetooth
®
wireless technology transformer and Mira Advance (J09N) shower:
• The Bluetooth
®
function of the Whale Instant Match
®
transformer will only work with the Mira Advanced Flex
Extra (J09N) shower. Previous Whale Instant Match
®
Wireless transformers cannot be connected wirelessly
to the Bluetooth
®
wireless technology enabled Mira Advance shower
®
.
• Bluetooth
®
wireless technology enabled transformers can be easily identified by the blue test button.
• For optimum signal strength mount the transformer within 5 meters of the shower.
• Locating the transformer outside of a 5 meter radius can cause a communication breakdown between
the transformer and shower, resulting in intermittent or complete failure to operate.
• Be aware that in very rare situations dense building material, metallic objects such as steel baths and
foil lined plaster board, or electronic devices may interfere with the Bluetooth
®
wireless technology signal
and result in intermittent failure. In this situation you should relocate the transformer closer to the shower.
• A hardwired connection should be established if a Bluetooth
®
wireless technology connection cannot be
made between the shower and transformer.
• If any components or cords are damaged, it must be replaced by a qualified person to avoid a hazard.
Set up
1. Shower settings
• Before beginning the Bluetooth registration process
please ensure that the “Pump LK2” switch inside the Mira
Advance (J09N) has been set to the “ON” position as per
the diagram shown.
• At this stage please ensure that your transformer is set to be
used with Bluetooth
®
wireless technology: the flow sensor
setting should be set to 7 for “Bluetooth” and the pipe inlet
diameter should be set to 1 for 15mm.