9
13. MAINTENANCE
14. INSTRUCTIONS FOR USE
For all Whale Twist® models
Clean housing and handset with warm soapy water.
Do not use any chemical cleaning agents.
Regular inspection of plumbing connections and tubing is recommended.
For Mixer Models
If you need to remove the handset and hose for replacement, remove the unit at the
valve housing and insert the temporary shut off valve as shown. (See Fig. 16a, 16b and
16c). This allows you to use the freshwater system until the new hose is installed.
STEP 1 Pull handset gently from the housing. (See Fig. 17)
STEP 2 Set fl ow / temperature. (Temperature settings do not apply for cold only
models). Twist handset to desired fl ow / temperature setting. (See Fig. 18)
CAUTION: For health and safety reasons, temperature should be set at 38ºC (100
ºF). Higher settings will increase the risk of scald injury. Those at greatest risk of scald
injury include children, the elderly, disabled, and diabetics.
Fig. 16a
Fig. 17
Fig. 18
Fig. 16b Fig. 16c
Temperature / fl ow indictor
To Next Page
Loading...
Need help?
General
