Wharfedale Pro Diamond 9.5 User Manual

The name ‘WHARFEDALE' is a registered trademark of Wharfedale
International Ltd.
Wharfedale has a policy of continuous product development and reserves
the right to change specification without notice.
Wharfedale is a member of the International Audio Group.
USA
IAG America, Inc.
15 Walpole Park
South
Walpole
MA 02081
CANADA
Korbon Trading Ltd
6800 Kitimat Road
Units 19-20
Mississauga
Ontario
Tel: +1 905 567 1920
UK
Wharfedale International Ltd.
IAG House, Sovereign Court,
Ermine Business Park,
Huntingdon,
Cambs PE29 6XU,
England.
Tel:+44 (0)1480 447700
Fax: +44 (0)1480 43176
AUTHORISED SERVICE CENTRES
For information on other authorised service centres worldwide contact
Wharfedale International in the U.K.
A worldwide distributor list is available on the Wharfedale website:
www.wharfedale.co.uk
COMPLIANCE
This Wharfedale product complies with the relevant clauses enshrined in the following standards and directives in force at the time of the
introduction of the product.
! EU Directives: 89/336/EC, 72/23/EEC: Safety: EN60065 (CB Scheme): Emissions: EN55013, EN61000 Immunity: EN55020:2002.
! USA: UL 6500:2002. Approved under the verification provision of FCC Part 15 as a Class B Digital Device.
! CANADA: CAN/CSA-E60065-00
Television picture colour is distorted Subwoofer too close to TV. (Switch off system and TV. Move units away. Leave 15 mins. Switch on)
Excessive bass distortion at low volumes
Subwoofer level set too high; LFE level set too high; Subwoofer incorrectly wired
Excessive or distorted bass at high levels
System level set too high; Bass control set too high; Speakers too close to room corners
Popping or thumping from the subwoofer
System level set high; Subwoofer level set too high; LFE level set too high
Indistinct sound; Poor localisation of
effects. Poor localisation of dialogue
One or more loudspeakers is out of phase
(Read the manual for correct connection procedure)
Distorted or rattling sounds at high levels
System level too high; Objects on speakers/subwoofer; Objects too close to subwoofer
Sound lacks bass content
Bass reproduction indistinct
Front loudspeakers out of phase.
Subwoofer not switched on; Subwoofer phase incorrect; Subwoofer crossover control too low
No Sound
System not switched on; Speaker cables shorting terminals out; Wrong source selected
Symptom Possible Cause
SW 250 will not respond to commands
Handset batteries weak; handset too far away; line of sight is impeded
TROUBLESHOOTING
If your system is not working properly please work through this checklist before returning a unit to your dealer. Before investigating a problem, always
switch off the system at the mains.
CARE AND MAINTENANCE
If you play the speakers with the grilles off exercise great care.
NEVER touch the drive units which are easily damaged.
The loudspeaker cabinets can be cleaned with a damp cloth or with
a spray furniture polish and a soft cloth. Apply the spray sparingly
to the cloth and then polish the cabinet. Never apply spray directly
to the cabinet.
GUARANTEE & SERVICE
In the unlikely even that your unit develops a fault you should
return it to your Wharfedale dealer using the original packing to
ensure safe shipping.
The terms of your guarantee may vary in different countries but in
all cases the guarantee excludes:
All damage caused through accident, misuse, wear and tear,
neglect, incorrect installation, adjustment or repair by
unauthorised personnel.
Liability for damage or loss occurring in transit to or from the
purchaser.
Wharfedale will not be liable for any consequential damage, loss
or injury, arising from or in conjunction with this equipment.
Diamond 9
Series
Instruction Manual
BRITAIN'S MOST FAMOUS LOUDSPEAKERS
9.0
9.1
9.2
9.3
9.4
9.5
9.6
9.CC
9.CS
9.CM
9.SR
9.DFS
SW 150
SW 250

Wharfedale Pro Diamond 9.5 Specifications

General

Configuration	3-way
Impedance	6Ω
Power Handling	150W
Recommended Amplifier Power	25-150W
Tweeter	25mm textile dome

Summary

Setting Up Two Subwoofers

General Notes for Subwoofer Setup

Site subwoofers to enhance bass response without cancellation.

Home Cinema Subwoofer Positioning

Spaced subwoofers fill troughs, smoothing bass and increasing intensity.

Stereo Subwoofer Positioning

Locate subwoofers near partnering loudspeakers for best results.

Preliminaries and Speaker Preparation

Unpacking and Retaining Speakers

Carefully remove loudspeakers from cartons, retaining packing.

Fitting Speaker Plinths and Spikes

Invert speakers, attach spikes to threads on the plinth.

Understanding Crossover Networks

Explains bi-wireable crossover panels and terminal binding posts.

Operating Your Wharfedale Subwoofer

Remote Handset Installation and Use

Covers installing batteries and using the remote for operation.

Subwoofer Power and Control Functions

Details switching on, volume, LPF, phase, and preset controls.

Setting Up Your Wharfedale Subwoofer

General Setup and Listening Room Considerations

General notes, room placement, and standing wave considerations.

Speaker Placement and Home Cinema Layouts

Advice on front, centre, and surround speaker placement in home cinema.

Diamond SW 250 User Instructions

SW 250 Preliminaries and Fitting

Unpacking, retaining materials, fitting feet, and rear panel overview.

SW 250 Connecting the Subwoofer

Power connections and connecting to A/V processor or stereo systems.

Diamond SW 150 User Instructions

SW 150 Preliminaries and Connections

Unpacking, rear panel overview, and connecting to A/V or stereo.

Control Panel Guide

Connecting the Subwoofer to Your System

Connecting to AV Processor or Stereo Amplifier

Methods for connecting to digital AV processors and stereo amplifiers.

Speaker Level Connections

Using high-level speaker connections when no line-level output is available.

Home Cinema Setup Procedures

Front and Effects Channel Placement

Positioning front, centre, and surround speakers for optimal effect.

Setting Loudspeaker Sizes in AV Processors

Guidance on setting speaker sizes ('Large'/'Small') in AV processors.

Setting Audio Levels and Delay

Adjusting channel levels for equal loudness and setting delay times.

Low Frequency Effects (LFE) Channel

Understanding the LFE channel and potential issues with bass frequencies.

Stereo and System Fine-Tuning

Stereo Reproduction and Low Pass Filter

Setting LPF based on main speaker size for optimal bass response.

Low-Level Listening Adjustments

Adjusting subwoofer volume for retention of bass at low listening levels.

Testing the System by Ear

Simple method to test system performance by listening.

Front Loudspeaker Connections

Standard Front Speaker Connection

Connecting front loudspeakers using standard single-wire cables.

Bi-Wired Speaker Connection

Connecting loudspeakers using two cables for improved headroom.

Centre Channel and Surround Loudspeaker Connections

Centre and Surround Speaker Wiring

Connecting centre and surround speakers using standard or bi-wired methods.

Positioning Front (Stereo) Loudspeakers

Optimal Placement for Stereo Speakers

Suggests placement at least 200mm from rear walls, facing inwards.

Important Safety Information

General Safety Precautions

Instructions on cleaning, ventilation, heat sources, and power cord protection.

Electrical Safety Warnings

Warnings about water exposure, opening covers, and fuse replacement.

FCC Compliance and Interference

Information on FCC rules for Class B digital devices and interference mitigation.

UK Mains Lead Wiring

Guidance on connecting mains lead colours to UK plug terminals.

Diamond 9 Loudspeaker Specifications

Bookshelf Monitor Specifications

Technical specifications for Diamond 9 bookshelf monitor models.

Floorstanding Loudspeaker Specifications

Technical specifications for Diamond 9 floorstanding models.

Audio Visual Loudspeaker Specifications

Technical specifications for Diamond 9 centre and surround speakers.