WHD AMP 4200 - Power Saving Mode

Manual AMP 4200
Valid for 111-425-04-001-00
Version (modifications reseverd)
21.02.2022
Seite 11 of 17
10.2.3. Power Saving
If “Auto” is selected as “Power Saving”, the amplifier goes into stand-by mode after an extended period
(approx. 20 min.) without an input signal.
You can use the trigger function e.g. if you use a control signal via a beamer (home cinema).
Note:
As soon as an input signal is present again, the amplifier is reactivated.