BEFORE YOU BEGIN
CAUTION: WHEELA is delivered with dismantled handlebars part. Follow these simple
instructions to make WHEELA ready for riding:
ASSEMBLY
1. MOUNT the handlebars part onto the top of
the front tube.
2. PUSH the stem firmly down onto the front
tube until it touches the collar.
3. ROTATE the handlebars relative to the front
tube so that the tips of the two white arrows
are aligned.
4. FASTEN the two nuts until the handlebars are
firmly fixed and do not move vertically (use
the wrench included within this manual).
Alternately apply equal amount of revolutions
on both nuts; do not tighten just one of the
nuts.
To Next Page
Loading...