31
4.4 Removal and Installation of Rear Wheel/s
(See Fig. 18)
Rear Wheel/s can be removed to facilitate storage at
home, in the trunk of your car or for general service.
WARNING
Before attempting to remove Rear Wheel/s, you need to
support the SUPERLIGHT by inserting any support block
under the Frame. The block should be large and strong
enough to allow the wheel/s to clear the ground by
approximately 3-4 cm (1.2-1.6 inch).
REMOVAL
a. Squeeze the center Pin in the Hub Cap
and pull the wheel off the axle.
INSTALLATION
b. Squeeze the center Pin in the Hub
Cap.
Push the wheel back on, to the end of
the axle.
WARNING
After installing the wheel please check carefully that it is
properly positioned and secured back in place.
c. To assure that the wheel is secured in
its place, try to pull it off axle without
touching the Pins. The wheel should
NOT come off. If necessary repeat
procedure b. above.
To Next Page
Loading...