5
2.2 Joining Tiller to Frame.
a. Place Tiller in front of the Frame. (See
Fig. 3).
Kneel at the left side of the
SUPERLIGHT holding the left side of
the Top Handle Bars of the Tiller with
your left hand. The Tiller should be
vertical and slightly inclined backward as
shown in Fig. 3.
b. With your right hand lift the Housing (at
the front end of the Frame) and place it
above the (black) Tapered Pin mounted
on the Tiller.
c. Let the Housing slide down onto the
black Tapered Pin until you hear a
“click”: at this time the Retaining Spring
should engage the Groove on the
Tapered Pin thus locking both sections
to each other.
To Next Page
Loading...