Need help?Do you have a question about the Whirlpool 240-VOLT ELECTRIC DRYER and is the answer not in the manual?
General| Fuel Type | Electric |
|---|---|
| Voltage | 240-Volt |
| Type | Electric Dryer |
| Brand | Whirlpool |
| Category | Dryer |
Explains DANGER/WARNING symbols and their meanings.
Warns about fire risks from improper installation and venting materials.
Lists essential safety rules for operating the dryer to prevent fire, shock, or injury.
Provides warnings about chemicals known to cause cancer or reproductive harm.
Identifies and explains the dryer's control panel buttons, knob, and indicator light.
Explains sensor dry cycles and recommends cycles for different fabric types.
Details timed dry cycles, their duration, and recommended fabric types.
Warns about explosion and fire hazards related to dryer operation.
Step-by-step instructions for powering on, setting temperature, and starting a cycle.
Instructions for keeping the dryer area clear for proper airflow and operation.
Guides on cleaning the dryer drum using detergent and water.
Detailed steps for cleaning the lint screen, including washing and drying.
Advises on removing lint from the dryer cabinet and exhaust vent periodically.
Provides guidelines for dryer care during non-use, storage, or moving.
Warns to disconnect power before servicing and risks of improper grounding.
Lists required tools and parts for dryer installation.
Outlines necessary requirements, including parts, pedestal, and stack kit options.
Specifies acceptable locations and clearances for dryer installation.
Provides detailed front, side, and back views with measurements.
Details spacing for recessed, closet, and undercounter installations.
Outlines specific installation needs for mobile homes.
Details electrical needs, codes, and supply requirements for installation.
Explains 3-wire vs 4-wire electrical connections and their requirements.
Provides guidance on proper grounding for cord-connected and permanently connected dryers.
Introduces procedures for power supply cord and direct wire installations.
Details attaching the power supply cord and strain relief.
Step-by-step guide for connecting a 4-wire power supply cord.
Instructions for connecting a 3-wire power supply cord.
Introduces direct wire connection procedures.
Detailed steps for connecting a 4-wire direct wire cable.
Steps for connecting a 3-wire direct wire cable.
Details requirements for dryer venting, including vent material and warnings.
Describes types of exhaust hoods and their installation.
Explains how to plan the vent system for optimal performance and clearance.
Specific venting requirements for mobile homes.
Step-by-step guide for installing the vent system, including hood and connection.
Provides a chart linking vent length, elbows, and vent types for drying performance.
Instructions for safely moving the dryer to its installed position.
Steps to ensure the dryer is level for proper operation and sensing.
A checklist to verify all installation steps are completed correctly.
Addresses problems like the dryer not running or not heating.
Explains common noises like thumping, rattling, or vibrating.
Troubleshoots issues like clothes not drying or taking too long.
Addresses problems where the cycle time is too short or too long.
Explains how a clogged lint screen affects the load.
Troubleshoots stains on clothes/drum and lingering odors.
Addresses causes and solutions for wrinkled clothes after drying.
Discusses issues with loads being too hot or drying too much.
Outlines the terms and duration of the limited warranty.
Lists items and situations not covered by the warranty.
Explains disclaimers for implied warranties and representations outside the warranty.
Provides guidance on seeking help, troubleshooting, and contacting Whirlpool.
Details how to order genuine replacement parts and accessories.
To Next Page
