Operating Your Air
Conditioner
In order to obtain the best possible results from your air conditioner, it is important that you
operate it properly. This section will tell you how to do just that.
Starting
your air conditioner
Fire Hazard
Do not use an extension cord.
Doing so can result in death, fire, or
electrical shock.
1. Set Fan Control
to the desired setting.
LOW COOL
. . . . . . . . . . . . for sleeping comfort
MEDIUM COOL
. . . . . . . . . . for normal cooling
HIGH COOL
. . . . . . . . . . . for maximum cooling
FAN ONLY
. . . . . . . . . . . for circulating room air
when no cooling is desired
2. Turn the Thermostat Control
to the
desired setting. You can adjust the air
conditioner’s cooling performance by
turning the Thermostat Control clockwise
for more cooling or counterclockwise for
less cooling. You will need to experiment
to find the setting which suits you best.
NOTE:
If you turn your air conditioner off or
if the compressor turns off when lowering
the Thermostat Control, wait at least 3
minutes before turning it back on. Doing
this keeps the air conditioner from blowing
a fuse or tripping a circuit breaker.
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Failure to follow these instructions
can result in death or electrical shock,
To Next Page
Loading...
Need help?
General
