Using the rinse agent dispenser
Keep the rinse agent dispenser filled with a
liquid dnse agent. A rinse agent greatly
improves dish drying by helping water
flow off them during the test rinse. A rinse
agent also keeps water h-oreforming
droplets and drying as spots or streaks.
A small amount of dnse agent automati-
cally releases intothe rinse water during the
final rinse of each cycle. For best drying
results, check dispenser periodically to
see if It needs filling.
To check dispenser:
• Check canter of Fill Indicator Cap. Clear
means itneeds filling,
OR
• Remove Fill Indicator Cap. An "E" isvisible
when dispenser is empty.
To fill dispenser:
The rinse agent dispenser holds 6 ounces
(175 mL). Under normal conditions, this
lests about 3 months.
1. Open dishwasher door completely.
2. Remove Fill Indicator Cap.
3. Add rinse agent. Fill to smallest opening
in lower part of dispenser only. Overfilling
may cause rinse agent to leak out. This
will not harm the dishwasher, but could
cause oversudsing.
4. Clean up any spilled rinse agent with a
damp cloth.
5. RepLaceFill Indicator Cap. Keep it closed
tightly.
NOTE: You do not have to wait untilthe
dispenser is empty before refilling, but do
not overfill it. Your dishwasher is designed
to use a liquid rinse agent. You do not need
to use a solid or bar-type rinse agent.
Q oR
Cap center clear "E" visible
when empty when empty
Do not fill past
smallest opening
Keep dispenser filled for best drying results
11
To Next Page
Loading...
