Before using your
refrigerator
1. Remove sales labels...
Remove the Consumer Buy Guide Label, tape
and any lnslde labels before using the refrigera-
tor. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing de-
tergent before removing glue as described in
step 1.
DO NOT USE sharp Instruments, rubblng alco-
hol, flammable flulds or abrasive cleaners.
These can damage the material. See “lmpor-
tant Safety InstructIons” on page 3.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
2. Clean it...
Clean your refrigerator before using it. See
cleaning instructions on pagell.
3. Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRlGERAiOR
3-PRONG
POWER
CORD
GROUNDING PLUG
RECOMMENDED GROUNDING
METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
sewing only this appliance be provided.
Do not use an extenslon cord. Use a recepta-
cle which cannot be turned off wlth a switch or
pull chain. See Electrical Requirements and
Grounding Instruction Sheet in your Literature
Package.
4. Install properly...
1. Allow YZ inch (1.25 cm) space on each side ar 1. Allow YZ inch (1.25 cm) space on each side ar
at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
slde closest to the wall so the door can be
opened wider.
3. The refrigerator back can be flush against the
wall.
4. Make sure ice maker water supply has been
connected. Refer to Installation Instructions.
5. Level refrigerator-freezer...
-
USE SCREWDRIVER
TO ADJUST
FRONT ROLLER
VELING SCREW
IGHT TO RAISE;
LEFT TO LOWER
1.
Remove base grille. (See page 8.)
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in direction shown.
4. Check with level.
5. Replace base grille. [See page 8.)
4
To Next Page
Loading...
