Using your refrigerator
FREEZER CONTROL
REFRIGERATOR CONTROL
EXTERIOR MOISTURE CONTROL
LIGHT SWITCH
Setting the controls...
Controls forthe refrigerator and freezer are in the
refrigerator. When the refrigerator is plugged in for
the first time...
1. Set the REFRIGERA-
TOR CONTROL to 3.
2. Set the FREEZER
CONTROL to B.
Give the refrigerator time to cool down com-
pletely before adding food. (This may take sev-
eral hours.]
These settings should be about right for nor-
mal household refrigerator usage.
The controls will be set about right when milk or
juice is as cold as you like and when ice cream is
firm.
Changing the control settings...
If you need to adjust temperatures in refrigerator
or freezer, use the settings listed in the chart below.
l Adjust the Refrigerator Control first.
l Wait at least 24 hours between adjustments.
l Then adjust the Freezer Control if needed.
RECOMMENDED
CONDITION: REASON:
CONTROL SETTINGS:
If Refrigerator
Door opened often
Refrigerator
4
Section is
Large amount of food added
Freezer
A
TOO WARM Room temperature too warm
If Freezer
Door opened often
Refrigerator
Section is
Large amount of food added
Freezer
:
TOO WARM Very cold room temperature
QUESTIONS?
(can’t cycle often enough)
call Your if Refrigerator
Controls not set correctly
Refrigerator
2
COOL-LINE@ Section is
for your conditions
Freezer
B
service
TOO COLD
assistance
telephone
If ICE isn’t Heavy ice usage
Refrigerator
3
number
MADE FAST ENOUGH
Very cold room temperature Freezer
C
(Page 18).
(can’t cycle often enough]
If BOTH SECTIONS Door opened often
Refrigerator
4
are TOO WARM Large amount of food added
Freezer
B
Very warm or very cold
room temperatures
Exterior Moisture Control
The Exterior Moisture Control on the Control
COnSOle
operates electric heaters around the
door openings. These heaters help keep moisture
from forming on the outside of the refrigerator.
I. Use the “OFF” setting when humidity is low.
2. Use the “ON” setting if moisture forms on the out-
side of the refrigerator.
5
To Next Page
Loading...
