What to do if my Whirlpool Washer machine is locked and shows an error code?
If your Whirlpool Washer is locked and displays an error code (e.g., F-..), try these steps: First, switch off the machine. Next, unplug it from the electrical outlet. Wait for about a minute, and then plug it back in and turn it on. If the issue continues after this, you may need to contact After-sales service.
How to fix a Whirlpool Washer that does not turn on?
If your Whirlpool Washer does not turn on, consider the following: * Ensure the plug is fully inserted into the electrical outlet. * Check for a power failure. * Make sure the door is completely closed.
What to do if the wash cycle does not start on my Whirlpool FFB 8469 SBV SPT?
If the wash cycle on your Whirlpool Washer isn't starting, here are a few things to check: * Make sure you've pressed the “ON/OFF” button. * Verify that you've pressed the “Start/Pause” button. * Ensure the water tap is open. * Check if a “Start delay” has been set.
What to do if my Whirlpool Washer does not fill and shows the 'h2o' message?
If your Whirlpool Washer isn't filling with water and the display shows “h2o” with a beep every 5 seconds, check the following: * Ensure the water intake hose is connected to the tap. * Make sure the hose isn't bent. * Verify the water tap is open. * Check that the mains water supply hasn't been shut off. * Ensure there's enough water pressure.
Why does my Whirlpool Washer keep loading and draining continuously?
If your Whirlpool Washer is continuously loading and draining water, consider these potential causes: * The “Start/Pause” button might not have been pressed. * The drain hose may not be installed at the correct height (65 to 100 cm from the ground). * The end of the drain hose could be immersed in water. * The drain connector on the wall might lack an air vent. If the issue remains after checking these, close the water tap, turn off the washing machine, and contact After-sales service. If you live on a high floor, anti-siphon valves might be needed to prevent this issue.
Why does my Whirlpool Washer vibrate so much during the spin cycle?
If your Whirlpool Washer vibrates excessively during the spin cycle, consider these possible reasons: * The drum might not have been properly unblocked during installation. * The washing machine might not be level. * The washing machine could be squeezed too tightly between furniture and the wall.
Why is my Whirlpool FFB 8469 SBV SPT leaking water?
If your Whirlpool Washer is leaking water, check these potential causes: * The water intake hose may not be tightened properly. * The detergent dispenser could be clogged. * The drain hose might not be properly fastened.
Why is my Whirlpool FFB 8469 SBV SPT Washer locked and not running?
If your Whirlpool Washer is locked and the program isn't running, it could be due to: * The door being locked due to a power breakdown. The program will continue automatically once power is restored. * The washing machine being in a standstill. The program will continue automatically once the cause of the standstill is resolved.
Why is too much foam forming in my Whirlpool Washer?
If your Whirlpool Washer is forming too much foam, it might be because: * The detergent isn't compatible with washing machines; it should say “for washing machines” or similar. * You might be using too much detergent.
To Next Page
General
