【The frequency matching description】
1) Wireless remote control has unique ID code corresponding to each of the particular
receiver, so the frequency matching is necessary.
2) Remote control and the machine has been matched frequency during assembling.
Please open
3) If the frequency is not matching properly, please do the following steps :
the back cover of the remote control and install the battery and lock the
cover then use the remote control.
Frequency button
Operation light
Mulfunction light
The air quality
indicator
The main body panel display picture
(right down part) :
-09-
(1) Check if the Main Body has connected to the power supply, and the remote control with battery.
(2) Press the frequency matching button (the right down of the main body panel) for 3 seconds ,the
buzzer will ring three times. If the operation light(green light) and the mulfunction light (red light)
simultaneously flashing, it means it is entering into the mode of automatic frequency matching.
(3) Press any button on the remote control ,if the buzzer rings three times ,it means the frequency
matching has finished.
To Next Page
Loading...
