Whirlpool K20 - Adjusting Ice Maker Settings; Adjusting Ice Cube Thickness

.@
,/'i
W.h,lfllxiol
L-"
K20lK40
ADJUSTING
THE ICE
CUBE
THICKNESS
lce
cube
thickness
is
pre-set
at the factory. The
thickness can be
increased
or
decreased
by
turning the thermostat knob with
a screwdriver.
Turning
the
knob
clockwise
increases
the thickness,
turning
it
anti-clockwise decreases
the
thickness. By means
of the thermostat knob it is
possible
to adjust
the
variations
due to the ambient temperature, when it
is
higher
than 32'C and
lower
than 10'C.
-
Never
turn
the thermostat
knob
outside
the
field indicated
on the dial.
-
Adjust
the ice thickness thermostat
only after a few hours operation and
only
after the bin
has half-filled
with ice
cubes.
-
Non-observance
of the thermostat
setting
rule
could
result in
damage to
the ice maker,
especially
if
the thermostat knob is left
on a
low
getting
in
a
high room
temperature.
In
this
case the ice could become
so thick the
ice will not
cut. On the other
hand,
the ice
thickness
could be reduced
to a
minimum
or none at all.