Whirlpool RT17DK - Changing the Control Settings; Removing the Drop-In Door Trim; Pieces

Changing the control settings
If you need to adjust temperatures in the
l Adjust the Refrigerator Control first.
refrigerator or freezer, use the settings listed
in the chart below as a guide. If you have
l Wait at least 24 hours between adjust-
ments.
questions, call our Consumer Assistance
Center number. (See page 23.)
l Then adjust the Freezer Control if needed.
CONDITION:
Refrigerator
section
too warm
Freezer
section
too warm
Refrigerator
section
too cold
Ice not
made fast
enough
Both sections
too warm
RECOMMENDED
REASON:
CONTROL SETTINGS:
Refrigerator
Freezer
. Door opened often
9 Large amount of food added
l Room temperature too warm
Qi z g
l Door opened often
l Large amount of food added
l Very cold room temperature
(can’t cycle often enough)
[i ,, iQ
l Controls not set correctly for
your conditions
(ji ,, y
. Heavy ice usage
l Very cold room temperature
(can’t cycle often enough)
Qi 1 ;Q
l Door opened often
l Large amount of food added
l Very warm or very cold room
temperatures
Removing the drop-in door trim pieces
To remove the trim piece:
1. Remove all items from the shelf.
2. Pull straight up on the trim piece at each
end.
To replace the trim piece:
4
1. Locate each end of the trim piece above
the trim pocket opening.
2. Push the trim piece straight down until it
stops.
3. Replace items on the shelf.
)
9