What to do if my Whirlpool Dryer will not run?
First, ensure the dryer door is completely closed. Then, touch and hold the START/PAUSE button for 2–5 seconds. Check your household fuses or circuit breakers; electric dryers often have two. Replace any blown fuses or reset tripped breakers. If problems persist, call an electrician to check the 240-volt power supply, which electric dryers require. Also, make sure you are using a time-delay fuse.
Why is my Whirlpool W10529641A not heating?
If your Whirlpool dryer's drum is turning but not heating, check your household fuses or circuit breakers. Electric dryers use two fuses or circuit breakers. Replace the fuses or reset the circuit breaker. If the problem continues, call an electrician to check the 240-volt power supply, which electric dryers require. For gas dryers, ensure the valve on the gas supply line is open.
What to do if my Whirlpool Dryer is making a rattling or vibrating noise?
A rattling or vibrating noise can be caused by several factors. Check the front and rear edges of the dryer drum for small objects and always clean out pockets before laundering. Ensure the dryer is properly leveled, with all four feet firmly contacting the floor. Also, separate clothing items to prevent them from balling up, which can cause the dryer to bounce and vibrate.
Why is there lint on my Whirlpool W10529641A load?
Lint on your load is often due to a clogged lint screen. Clean the lint screen before each load. Also, check the exhaust vent or outside exhaust hood for clogs, which restrict air movement. To test, run the dryer for 5–10 minutes and check for air movement under the exhaust hood. If there's no air movement, clean the exhaust system or replace the vent with a heavy metal or flexible metal vent.
Why is my Whirlpool W10529641A making a tumbling noise?
If your Whirlpool dryer hasn't been used in a while, a tumbling noise is normal. The thumping sound should diminish after a few minutes of use.
Why does my Whirlpool W10529641A make a humming or whining noise during the Steam cycle?
The humming or whining noise during the Steam cycle is likely due to the water inlet valve running. This is normal, especially if the dryer has just been installed or hasn't been used for a while. The valve may be louder and run longer in these cases, even without a water line connected.
What does a clicking noise in my Whirlpool W10529641A Dryer mean?
On gas dryers, a clicking noise indicates the gas valve is opening and closing, which is normal operation.
To Next Page
General