EN
Quick guide
* Available only on certain models
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT
In order to receive a more complete assistance, please
register your product on www . whirlpool . eu/ register
Before using the appliance carefully read the Safety
Instruction.
FIRST TIME USE
After installation, wait at least two hours before connecting the
appliance to the power supply. Once connected, it will start working
automatically. The ideal temperature settings are preset from the
factory.
After turning the appliance on, wait 4-6 hours for it to reach the correct
food storage temperature.
CONTROL PANEL
1. Indicator Leds (to display the current temperature set point or the
Fast Cooling function)
2. Fast Cooling Button / Temperature Button
TEMPERATURE SETTING
Press the Temperature button on the control panel to adjust the
temperature from the warmest through the lower to the coldest
level. Pressing the Temperature button, the temperature setting will
change cyclically. At rst plug-in of appliance temperature setpoint is
present at medium position (factory setting). Following table shows
temperature setpoints:
OFF ON
High temp.
Med-high temp.
Medium temp.
Med-low temp.
Low temp.
Fast cooling
Recommended setting:
• Refrigerator compartment: +4°C or MED
• Freezer compartment: -18°C or -20°C
Note: Displayed set points correspond to the average temperature
throughout the whole refrigerator.
FAST COOLING
The use of the Fast Cooling function is recommended to increase the
cooling capacity of the refrigerator compartment when placing a very
high quantity of food within it.
To activate the Fast Cooling function, press and hold for 3 seconds the
Temperature button on the control panel till all the 3 LEDs will turn on.
The function is automatically deactivated after 24 hours and return to
previous selected set point.
The function can be manually deactivated by pressing and holding for
3 seconds the Temperature button on the control panel.
Note: Fast Cooling function should be also switched ON before placing
fresh food to be frozen in the freezer compartment, in order to maximize
the freezing capacity.
LED LIGHT
This product contains a light source of energy eciency class G.
If the LED light system does not work, please contact the Service to
replace it.
Important: The refrigerator compartment light switches on when
the refrigerator door is opened. If the door is kept open for more than
8 minutes the light will be automatically switched o.
6
TH
SENSE
This function automatically works to ensure the optimal conditions
to preserve the stored food. The “6th Sense” function is automatically
activated when:
• a large amount of food is loaded into the refrigerator
• the refrigerator door is left open for a long time
• a prolonged power failure takes place, causing the internal
temperature of the appliance to increase to values that cannot
guarantee safe storage of food.
To Next Page
General
