EasyManua.ls Logo

Whirlpool WGD4950HW - User Manual

Whirlpool WGD4950HW
2 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Gas and Electric Dryer
PRODUCT MODEL NUMBERS
W10848818A
01/18
WED4950HW, WGD4950HW, WED4850HW,
WGD4850HW, YWED4850HW
Installation clearances:
For each arrangement, consider allowing more space for ease of
installation and servicing, spacing for companion appliances, and
clearances for walls, doors, and oor moldings. Space must be
large enough to allow door to fully open. Add spacing on all sides
of dryer to reduce noise transfer. If a closet door or louvered door
is installed, top and bottom air openings in door are required.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
Dryer Dimensions
Front View
50
3
/4"
(1289 mm)
42"
(1067 mm)
28
1
/4"
(717 mm)
28
1
/4"
(717 mm)
NOTE: Minimum height of leveling legs should be 1/2" (13 mm),
or high enough for dryer to match the height of the accompanying
washer.
Side View
29"
(737 mm)
40
7
/8"
(1038 mm)
1
/2"
(13 mm)
A B
A. Wide opening side-swing door
B. Wide opening hamper door
Back View
14
1
/
2
"
(368 mm)
4
3
/4"
(121 mm)
9
1
/4"
(235 mm)
1
1
/4"
(32 mm)
14
1
/
2
"
(368 mm)
4
3
/4"
(121 mm)
9
1
/4"
(235 mm)
1
1
/4"
(32 mm)
30
1
/4"
(768 mm)
4"
(101 mm)
Non-Steam
Installation spacing for recessed area
or closet
The dimensions shown are for the minimum spacing allowed.
■ Additional spacing should be considered for ease of
installation and servicing.
■ Additional clearances might be required for wall, door,
and oor moldings.
■ Additional spacing of 1" (25 mm) on all sides of the dryer
is recommended to reduce noise transfer.
■ For closet installation, with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are
acceptable.
■ Companion appliance spacing should also be considered.
Installation Spacing
6"/0"
(152 mm/
0 mm)
14" max
(356 mm)
1"/0"
(25 mm/0 mm)
1"/1"
(25 mm/25 mm)
18"/18"
(457 mm/
457 mm)
3"/3"
(76 mm/
76mm)
3"/3"
(76 mm/
76mm)
48"
2
/48"
2
(310 cm
2/
310 cm
2
)
24"
2/
24"
2
(155 cm
2/
155 cm
2
)
Recommended/Minimum spacing
Steam

Other manuals for Whirlpool WGD4950HW

Preview: Use And Care Guide
Use And Care Guide28 pages

Questions and Answers

  • J
    John SavageAug 18, 2025
    What to do if my Whirlpool WGD4950HW won't start?
    • S
      srichardsAug 18, 2025
      If your Whirlpool dryer will not run, first ensure that the dryer door is closed completely. Then, press and hold the PUSH to START knob until you hear the dryer drum moving. Also, check your household fuses or circuit breakers, as electric dryers use two. Replace both fuses or reset the circuit breaker. If the problem continues, call an electrician. Ensure your electric dryer has a 240-volt power supply by checking with a qualified electrician, and use a time-delay fuse.
  • J
    Julia WhiteAug 21, 2025
    Why does my Whirlpool Dryer make unusual sounds?
    • Q
      qnashAug 21, 2025
      Unusual sounds from your Whirlpool dryer can stem from several causes. If the dryer hasn’t been used for a while, a thumping sound may occur during the first few minutes. Check the front and rear edges of the drum for small objects such as coins, buttons, or paper clips. For gas dryers, the gas valve clicking is a normal operating sound. The dryer may vibrate if not properly installed, so refer to the Installation Instructions. If clothing is knotted or balled up, separate the items and restart the dryer. Also, make sure the supply line valve is open for gas dryers.
  • T
    tiffany25Aug 25, 2025
    How to prevent wrinkles in my Whirlpool WGD4950HW Dryer?
    • D
      David SuttonAug 25, 2025
      To prevent wrinkles when using your Whirlpool Dryer, select the Wrinkle Shield™ feature to tumble the load without heat at the end of the cycle. Also, dry smaller loads that can tumble freely to reduce wrinkles from forming. Make sure to remove the load from the dryer at the end of the cycle.
  • E
    Evelyn EatonAug 27, 2025
    What to do if my Whirlpool WGD4950HW Dryer cycle time is too short?
    • S
      Scott DixonAug 27, 2025
      If your Whirlpool dryer's automatic cycle is ending early, the load may not be contacting the sensor strips. Try leveling the dryer. For very small loads, use Timed Dry. You can also change the Dry Level setting on ACCUDRY™/Automatic Dry cycles to increase or decrease the drying time.
  • S
    Steve CaldwellAug 30, 2025
    Why is there lint on my clothes after using my Whirlpool WGD4950HW?
    • M
      Matthew FrancoAug 30, 2025
      If you find lint on your clothes after using your Whirlpool Dryer, the lint screen is likely clogged. Clean the lint screen before each load.
  • J
    Jose BauerSep 3, 2025
    Why is my laundry too hot after using my Whirlpool Dryer?
    • C
      Crystal EstradaSep 3, 2025
      If your laundry items are too hot after using your Whirlpool Dryer, it may be because they were removed before the end of the cycle. Allow the Cool Down cycle to finish before removing laundry. Also, if a high-temperature cycle was used, select a lower temperature and use an automatic drying cycle, which senses the temperature or moisture level and shuts off when the load reaches the selected dryness, reducing overdrying.
  • S
    Scott GarciaSep 6, 2025
    What causes stains on clothes or drum in my Whirlpool WGD4950HW?
    • C
      Connor NelsonSep 7, 2025
      Stains on clothes or the drum in your Whirlpool Dryer can be caused by dryer fabric softener not properly used. Add dryer fabric softener sheets at the beginning of the cycle, as adding them to a partially dried load can stain garments. Drum stains are often caused by dyes in clothing, such as blue jeans; these stains will not transfer to other clothing.
  • P
    Paul PerezSep 10, 2025
    Why does my Whirlpool Dryer smell?
    • A
      Albert BurgessSep 10, 2025
      If your Whirlpool dryer smells, it could be due to recent painting, staining, or varnishing in the area. Ventilate the area, and rewash and dry the clothing when the odors or fumes are gone. If it is a new electric dryer, the new heating element may have an odor that will disappear after the first cycle.
  • S
    Sara LiNov 13, 2025
    How to fix Whirlpool WGD4950HW taking too long to dry clothes?
    • J
      justinliNov 13, 2025
      If your Whirlpool Dryer is taking too long to dry clothes, the lint screen may be clogged and should be cleaned before each load. Also, ensure you've selected the right cycle for the garments you're drying, as the Fluff Air cycle or No Heat setting can extend drying times. A large, heavy load can also increase drying time. Check that the exhaust vent or outside exhaust hood isn't clogged with lint, restricting air movement. Run the dryer for 5-10 minutes and check for air movement under the exhaust hood. Clean the exhaust system if needed, or replace the vent with a heavy metal or flexible metal vent, ensuring it's not crushed or kinked. Fabric softener sheets can also block the grille if you use too many or reuse them. Use only one sheet, and only once. Finally, check that the exhaust ven...

Summary

Installation Clearances and Dimensions

Dryer Unit Dimensions

Details front, back, and side view dimensions of the dryer unit for installation planning.

Installation Spacing Requirements

Provides minimum and recommended spacing for recessed areas, closets, and general installation.

Installation Requirements

Gas Supply Requirements

Details natural gas and L.P. gas connection requirements, including pipe size and shut-off valve.

Electrical Requirements

Specifies electrical supply needs for gas and electric models, including voltage and circuit type.

Water Requirements (Steam Models)

Covers cold water faucet connection, pressure, and hose requirements for steam models.

Venting Requirements Overview

Explains essential outdoor venting rules, materials, and safety warnings to prevent fire.

Vent System Chart Guidance

Provides chart for acceptable vent types, lengths, and elbows for optimal drying performance.

Whirlpool WGD4950HW Specifications

General IconGeneral
BrandWhirlpool
ModelWGD4950HW
CategoryDryer
LanguageEnglish

Related product manuals