EasyManua.ls Logo

Whirlpool WRF736SDAF00 - Doors

Whirlpool WRF736SDAF00
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The ice dispenser jams Crushed ice is blocking the ice Switch from crushed ice to cubed ice to clear the ice
while dispensing crushed delivery chute, dispenser. Then switch back to crushed ice.
ice
Water is leaking or dripping The glass was not held under the Hold the glass under the dispenser 2 to 3 seconds after
from the dispenser system dispenser long enough, releasing the dispenser lever.
NOTE: A few drops of water
after dispensing is normal.
Water continues to drip The refrigerator has just been Flushing the water system removes the air from the lines
from the dispenser beyond installed, which causes the water dispenser to drip. Flush the water
the first few drops, system. See "Water and Ice Dispensers."
The water filter was recently installed Flushing the water system removes the air from the lines
or replaced, which causes the water dispenser to drip. Flush the water
system. See "Water and Ice Dispensers."
Water is leaking from the The water line connections were not See "Connecting the Water."
back of the refrigerator fully tightened.
Recently removed the doors and did See "Refrigerator Doors and Drawer."
not fully tighten water line connection
Water from the dispenser is Water from the dispenser is chilled to This is normal.
warm 50°F (10°C).
The refrigerator has just been Allow 24 hours after installation for the water supply to cool
installed, completely.
A large amount of water was recently Allow 3 hours for the water supply to cool completely.
dispensed.
Water has not been recently The first glass of water may not be cool. Discard the first
dispensed, glass of water dispensed.
The refrigerator is not connected to a Make sure the refrigerator is connected to a cold water pipe.
cold water pipe. See "Water Supply Requirements."
Doors
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search
for "door closing and door alignment."
The doors will not close The door is blocked open. Move food packages away from door.
completely ....................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................
A bin or shelf is in the way. Push bin or shelf back into the correct position.
Recently installed Remove all packaging materials.
The doors are difficult to The door gaskets are dirty or sticky. Clean gaskets and contact surfaces with mild soap and
open warm water. Rinse and dry with soft cloth.
35

Table of Contents

Related product manuals