OPERATIONOPERATION
14 15
Stay Alert Feature
The Stay Alert Feature is designed to test a driver’s alert-
ness. To engage (when unit is not alarming):
• P ress and hold City for approximately 2 seconds.
Release button during or immediately after the alert is
given. Display reads:
Within 30-60 seconds two beeps are sounded; to show alert-
ness, the driver must press either the City or Quiet button
within 3-5 seconds. If the button is pressed within 3-5 seconds,
the cycle is re p e a t e d .
If a button was not pressed within 3-5 seconds alarm sounds
and the display re a d s :
• Press Power to exit.
WA R N I N G ! ! ! Stay Alert is NOT intended as a substitute for
adequate rest. You should NOT operate a vehicle if you are
d ro w s y. During extended periods of vehicle operation, you
should take frequent breaks. Improper reliance on the Stay
A l e rt feature may result in vehicle damage, personal injury or
d e a t h .NEVER OPERATE A VEHICLE IF YOU ARE DROWSY.
Dim/Dark Mode
Dim/Dark Mode reduces the illumination of the display.
• P ress and hold Power for 2 seconds to reduce illumination
to a Dim setting. Display re a d s :
• P ressing and holding the power button for 2 seconds a
second time engages Dark Mode. Display re a d s :
Dim or dark can be engaged during an alert. In Dark Mode,
the display goes dark for as long as a signal is being detect-
ed and for 20 seconds after, then the display re t u rns to the
dimmer setting.
• P ressing and holding the power button a third time
re s t o res full illumination to the display.
Engaging/Disengaging VG-2
See option select mode to turn this feature on.
1750/1760/1765 manual 3/6/02 2:20 PM Page 17
To Next Page
Loading...
Need help?
General
