Operation
The inverter will turn itself off automatically when:
1. The power input from the battery drops to 10 volts.
2. The power input from the battery exceeds 15 volts.
3. The continuous draw of the equipment or appliance
being operated exceeds 100 watts.
The surge draw of the equipment or appliance being
operated exceeds safe operation.
Don’t Blow A Fuse.
This inverter is equipped with an internal spade type
fuse(s). With reasonable care, it should not be necessary to
replace the fuse(s) in your inverter.
Most blown fuses are the result of reverse polarity or a
short circuit within the appliance or equipment being
operated. If the fuse(s) does blow, turn off and disconnect
the appliance or equipment from the inverter immediately,
repair the related problem and replace the fuse(s). The
internal fuses are replaceable, however only electronically
knowledgeable people should attempt fuse replacement.
NOTE:
• Make certain to correct the source of the overload which
caused the blown fuse before turning your inverter back ON (l).
OPERATION
9
To Next Page
Loading...
Need help?
General
