EasyManua.ls Logo

White Outdoor 10.5-28 - User Manual

White Outdoor 10.5-28
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Safety • Assembly • Operation • Adjustments • Maintenance • Troubleshooting • Parts Lists • Warranty
60 Ottawa Street South, KITCHENER, ONTARIO N2G 4J1
PRINTED IN U.S.A.
IMPORTANT:
READ SAFETY RULES AND
INSTRUCTIONS CAREFULLY
BEFORE OPERATION
OPERATOR’S MANUAL
Two-Stage Snow Throwers 8.5-26 and 10.5-28
7/13/2005
772C0775

Questions and Answers

  • M
    Mark DawsonAug 6, 2025
    What to do if my White Outdoor Snow Blower engine fails to start?
    • E
      Emily NelsonAug 6, 2025
      If your White Outdoor Snow Blower engine won't start, there are several potential causes. First, ensure the choke is in the ON position. Next, check that the spark plug wire is connected. The fuel tank may be empty or contain stale fuel, so fill it with clean, fresh gasoline. Also, prime the engine as instructed. Other possible issues include a faulty spark plug (clean, adjust gap, or replace), a blocked fuel line (clean it), the safety key not fully inserted, or the fuel shut-off valve being closed (open it).
  • M
    Michael ClarkAug 11, 2025
    Why does my White Outdoor Snow Blower engine run erratically?
    • L
      Larry OrtegaAug 11, 2025
      An erratic engine in your White Outdoor Snow Blower can stem from a few issues. Check if the unit is running on CHOKE and move the lever to the OFF position. A blocked fuel line or stale fuel could also be the culprit; clean the fuel line and refill the tank with fresh gasoline. Water or dirt in the fuel system can also cause this, so drain the tank and refill with fresh fuel. If these steps don't resolve the issue, the carburetor may need adjustment, and you should contact a service center.
  • R
    randy36Aug 16, 2025
    What to do if my White Outdoor Snow Blower fails to discharge snow?
    • D
      Daniel KochAug 16, 2025
      If your White Outdoor Snow Blower isn't discharging snow, immediately stop the engine and disconnect the spark plug wire before taking any action. A clogged chute assembly is a common cause; clean it along with the inside of the auger housing using a clean-out tool or stick. Also, check for any foreign objects lodged in the auger and remove them with a clean-out tool or a stick. Other potential issues include the auger control cable needing adjustment, a loose or damaged auger belt, or sheared shear pins (replace them with new ones).
  • B
    Billy BallAug 21, 2025
    Why is my White Outdoor Snow Blower losing power?
    • M
      Michelle MyersAug 21, 2025
      Loss of power in your White Outdoor Snow Blower can be attributed to a few reasons. First, ensure the spark plug wire is securely connected and tightened. Check the gas cap for any ice or snow that may be plugging the vent hole and clear it. If the exhaust port is plugged, contact a service center for assistance.
  • R
    Roberto WrightAug 27, 2025
    Why does my White Outdoor Snow Blower have excessive vibration?
    • D
      Debbie SmithAug 27, 2025
      Excessive vibration in your White Outdoor Snow Blower may be due to loose parts or a damaged auger. Stop the engine immediately, disconnect the spark plug wire, and tighten all bolts and nuts. If the vibration persists, have the unit serviced by a Service Center.
  • S
    Scott PottsAug 31, 2025
    What to do if my White Outdoor Snow Blower won't propel itself?
    • A
      Adam BrownAug 31, 2025
      If your White Outdoor Snow Blower isn't moving on its own, the drive control cable may need adjustment. Refer to the “Adjustments” section for instructions. Alternatively, the drive belt might be loose or damaged, requiring replacement.

Summary

Safety Labels

Safe Operation Practices

Training for Safe Operation

Essential guidelines for learning safe operation of the snow thrower.

Pre-Operation Preparation

Steps to prepare the machine and the operating area before use.

Setting Up Your Snow Thrower

Drift Cutters Installation Guide

Instructions for installing drift cutters for heavy drift conditions.

Operating Your Snow Thrower

Engine Starting and Stopping

Procedures for starting and stopping the snow thrower engine.

Auger Control Safety Test

Test procedure to ensure the auger control functions safely.

Making Adjustments

Shift Cable Adjustment

Adjusting the shift cable for proper speed engagement.

Chute Control Cable Adjustment

Adjusting chute control cables for directional and pitch changes.

Drive Control Cable Adjustment

Adjusting the drive control cable for proper engagement.

Skid Shoe Adjustment

Adjusting skid shoes for different surface conditions.

Maintaining Your Snow Thrower

Component Lubrication Guide

Recommendations for lubricating gear shafts, wheels, and other parts.

Auger Belt Replacement Procedure

Step-by-step instructions for replacing the auger belt.

Friction Wheel Service

Procedures for removing and servicing the friction wheel assembly.

Off-Season Storage

Trouble-Shooting Guide

Limited Warranty Information

White Outdoor 10.5-28 Specifications

General IconGeneral
ManufacturerWhite Outdoor
EngineBriggs & Stratton
Engine Displacement305 cc
Clearing Width28 inches
Throw Distance40 feet
Starter TypeRecoil

Related product manuals