White's TREASUREmaster - Tone Identification

13
Tone Identication
The pitch or audio frequency produced by each target’s
display identication range can be highlighted with differently
pitched sounds, called Tone Identication.
With a specic audio pitch reference for each range, one is
immediately aware of that target’s identication range based
on the pitch of the beep it produces during searching without
looking at the display.
When Tone Identication is in single tone, all accepted metal
types produce the same audio pitch during searching. If the
Discrimination is set to reject a specic target range, that range
may not produce a beep of any pitch.
To Adjust Tone Identication:
1. Press Options and use Up & Down arrows to
select Tone ID.
2. Press (+) & (-) to select Tone Identication
and type.
3. Press Options to exit.
TREASUREmaster®
When 2-Tone is selected:
• Iron = Lowest Tone (if accepted), no tone if rejected
• All other targets produce a slightly higher pitch
When 4-Tone is selected:
• Iron = Lowest pitch beep (if accepted)
• Foil = Slightly higher pitch beep (if accepted)
• Tab = Slightly higher pitch beep (if accepted)
• All Coins = Highest pitched beep