White 1010 - Adjusting Lower Tension; Drop Feed Lever

Adjusting
Lower
Tension
To test bobbin
tension, hang
and
shake bobbin
case as
shown.
At proper tension
bobbin case
will
gradually
drop
a
small
amount
To
adjust tension, turn
adjusting
screw
with small screwdriver.
Raise
needle in the
highest
position
Leave
end of
thread
of about
10
cm
(4”) from
bobbin
case.
Take
hold of latch
and push
bobbin
case
into hook.
Release latch
when bobbin
case
is fully
inserted.
Drop
Feed Lever
The lever
is
on right
side
of
hook.
To
lower
feed dog, move
lever
down
to
position.
This
position is for button
sewing,
darning
and embroidery.
For
normal sewing, move
lever
up to
AAposition.
‘oosen
—12—