White 1268 - How to Use Accessories; Narrow Hemmer; Lace Trimmed Hem

Remove
the
toothpick and wind
thread
under
button,
forming a shank.
Fasten.
Apply
the above method
to
sew
on buttons with
four
holes,
hooks, and
snaps etc.
If a
four hole button
is to be
sewn, follow the
same
procedure above
for the two
hole button.
Now lift
presser
foot slightly and
move fabric to
permit
stitching
the remaining two
holes. Hooks,
snaps, etc.,
are sewn
to the fabric
with the same
procedure
as
for
sewing two hole buttons.
HOW TO
USE
ACCESSORIES
NARROW
HEMMER. With
the needle
at its
highest position,
replace
regular presser
foot with
narrow
hemmer
(Fig.
28).
For a plain narrow
hem,
make a 1/8
inch double
fold for about two
inches
ilong
edge
of
fabric. Hold
each end of the
two
inch
fold,
slip underneath
hemmer.
Bring fold
up into
the
scroll
of
hemmer. Draw
forward
to end
and
fas
ton
with
point
of
needle.
Lower presser bar
lifter.
(ently
pull
ends of
thread
as you start stitching.
Guide
material
slightly
to right, and it
will take
i
double
turn
through
scroll.
LACE
TRIMMED
HEM.
To
sew a narrow
hem
dnd
attach
lace
in one stitching,
insert lace in the
:lot
next to
needle
(Fig.
29).
Sew hem
as above,
guiding lace
under needle and
hem
into
scroll.
Fig.
28
Fig. 29