Need help?Do you have a question about the White Snow Boss 550 and is the answer not in the manual?
General| Auger Material | Steel |
|---|---|
| Wheels | Yes |
| Type | Two Stage |
| Engine Type | 4-stroke |
| Starter Type | Recoil |
Essential training for new operators and critical safety measures before use.
Steps to ensure the snow thrower and operating area are ready for use.
Detailed instructions for safe and effective snow thrower operation.
Overview of essential maintenance and storage preparation.
Explanation of shear bolts and their purpose in protecting the auger.
Steps for assembling the handle, shift rod, and chute crank.
Instructions for installing the headlight and specific chute crank for 5.5 HP models.
Adjusting clutch mechanisms for proper cable tension and engagement.
Fine-tuning the shift lever and skid shoes for optimal performance.
Recommended tire pressure for correct operation and handling.
Using the shift lever for speeds and engaging/disengaging drive clutches.
Adjusting the chute's direction and the angle for snow throw distance.
Operating the throttle, ignition key, and fuel shut-off valve.
Information regarding the operation of the snow thrower's headlight.
Instructions for filling the fuel tank and checking engine oil levels.
Step-by-step guide for starting the engine via electric or recoil methods.
Safe methods for shutting down the snow thrower engine.
How to engage the traction drive and auger clutches for snow removal.
Advice for efficient operation and guidelines for using optional tire chains.
Adjusting the chute angle to control snow discharge distance.
Adjusting skid shoes for ground clearance and traction drive for performance.
Procedures for adjusting the auger clutch and shift rod for optimal function.
Setting up drive wheels for one-wheel or two-wheel drive operation.
Lubrication points for the engine, auger shaft, and bearings.
Lubricating wheel bearings, axles, and the chute crank gear.
Lubricating gear shafts, drive mechanisms, and clutch lock cams.
Information on gear case lubrication and maintaining the vent plug.
Inspecting and replacing augers, shear bolts, shave plate, and skid shoes.
Steps for removing and reinstalling the auger drive belts.
Detailed steps for removing and installing the main drive belt.
How to replace worn or cracked friction wheel rubber.
Draining fuel or using stabilizer to prevent gum deposits.
Lubricating cylinder, cleaning, and rust-proofing for long-term storage.
Solutions for engine failure to start or erratic running.
Addressing loss of power, excessive vibration, and shifting difficulties.
Troubleshooting propulsion, auger engagement, and snow discharge issues.
Procedure for getting service and submitting warranty claims.
Details on what the limited warranty covers and its limitations.
To Next Page
