Care and Maintenance
CLEANING YOUR APPLIANCE
•
Turn off the power, unplug the appliance, and remove all contents from the appliance and store them in a suitable place.
•
Clean the inside, the door seal and the inside of the glass with a clean, damp cloth.
•
Never use detergents or other substances that emit odors.
•
Always keep the door closed when cleaning the outside of the appliance. Make sure no detergent odors penetrate into the
appliance.
•
Clean the side panels and door surfaces with a clean and soft cloth. If necessary, use a moist cloth. Alternatively, use a
microfiber cloth.
•
The humidity tray should be hand-washed with water and detergent. After cleaning, always make sure the tray is thoroughly
rinsed with clean water before replacing.
PREMISES POWER FAILURE
•
In the event of a power interruption, temperature settings automatically defaults to factory settings once power is restored.
•
Factory default temperature setting is 40
°
F. To set a different desired temperature,
refer to the "SETTING THE TEMPERATURE" and "
°
C and
°
F SELECTOR" section on page 10.
•
Most power failures are corrected within a few hours and should not affect the temperature of your appliance if you
minimize the number of times the door is opened. If the power is going to be off for a longer period of time, yo
u need to
take th
e proper
steps to protect your contents.
VACATION TIME
•
Short vacations: Leave the appliance operating during vacations of less than two days.
•
Long vacations: If the appliance will not be used for an extended period, remove all items and turn off the appliance. Clean
and dry the interior thoroughly.
MOVING YOUR APPLIANCE
•
Remove all items inside th e appliance.
•
Securely tape down ( we recommend using painter's tape ) all loose items ( shelves ) inside your appliance.
•
Turn the adjustable legs up to the base to avoid damage.
•
Tape ( we recommend using painter's tape ) the door shut.
•
Be sure the appliance stays secure in the upright position during transportation and protect the exterior of appliance with a
blanket, or similar item.
PREPARING FOR STORAGE
If the beverage refrigerator will not be used for a long time, or is to be moved to another place, it will be necessary to
defrost the unit and dry the interior.
1.
Disconnect the beverage refrigerator from the power supply by removing the power plug from the wall socket.
2.
Leave the door open to allow for air circulation and to prevent mold, mildew and unpleasant smells.
CAUTION: Store the unit out of the reach of children. If you have children, you may want to take additional
precautions such as removing the door to prevent a child from being trapped inside the beverage refrigerator.
•
NOTE:
•
•
•
•
•
•
If the beverage refrigerator is unplugged, encounter power lost, or turned off; you must wait 3 to 5 minutes before
restarting the beverage refrigerator.
When the beverage refrigerator is used for the first time or restarted after having been shut off for a long time, there could be
a few degrees variance between the temperature you select and the one indicated on the display. This is normal and it is due
to the length of the inactivation time.
The appliance should be located in the coolest area of the room, away from heat producing appliances , and out of any
direct sunlight.
Ensure that the appliance is adequately ventilated. Never obstruct the air vents.
Close the door tightly and do not open the appliance too frequently or for a long period of time.
Store the content in an organized way.
Do not over load the appliance to allow air to circulate.
1
3
To Next Page
Loading...
Need help?
General
