Tools needed: flathead screwdriver, Phillips screwdriver
CAUTION: Before you begin, unplug the beverage refrigerator from power.
To remove the door:
1. Using a flathead screw driver carefully pry the top hinge cover off.
2. Using a Phillips screwdriver, remove the screws and take off top hinge. Keep the parts together
and set them aside.
3. Lift the door off the bottom hinge and set the door aside.
4. Remove the bottom hinge by removing the screws with a Phillips head screwdriver.
To install the door:
1. Using a flathead screwdriver, remove the plugs and cover from the opposite cabinet top corner
and from the door. Set aside.
2. Install the bottom hinge at the opposite side corner and fasten the screws.
3. Position the door on the bottom hinge.
4. Align the door on the bottom hinge and install the top hinge.
5. Push the plugs and covers into the corresponding holes.
LEVELING THE APPLIANCE
It is important for the beverage refrigerator to be leveled in order to work properly. It can be raised or
lowered by rotating each of the feet on the bottom of the machine. If you find that the surface is not
level, rotate the feet until the beverage refrigerator becomes level .You may need to make several
adjustments to level it. We recommend using a carpenter’s level to check the machine.
1. Place a carpenter’s level on top of the product to see if the beverage refrigerator is level from
front to back and side to side.
To Next Page
Loading...
Need help?
General
