loaded.
To level your appliance, adjust the leveling legs at the bottom of the appliance if needed.
Allowance of at least 5 inches (127mm) of space between the back and sides of the
appliance are suggested, which allows the proper air circulation to cool the
compressor and condenser.
We do not recommend installing the appliance on carpet.
Do not install the appliance near an oven or other heating source. Direct sunlight may affect the
acrylic coating and heat sources may increase electrical consumption. For best performance, do
not install the appliance behind a cabinet door or block the base grille. Extreme cold ambient
temperatures may also cause the appliance not to perform properly.
Avoid locating the appliance in area that may be exposed to excessive moisture.
Plug in the appliance into an exclusive, grounded wall power outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a qualified electrician or an
authorized service center.
INSTALLATION LOCATION
Your beverage refrigerator should be conveniently located for day-to-day use in a dry, well-ventilated
room.
Do not install the appliance where the temperature will go below 60°F or above 90°F, because it will
not maintain proper temperatures. Be sure to install your beverage refrigerator on a floor strong
enough to support it when it is fully loaded.
FREESTANDING INSTALLATION
A freestanding installation will allow you to install the beverage refrigerator in any place you desire
provided that the required clearance space around the appliance is respected. In every setting, there
must be an adequate ventilation and access for service. Never install or operate the unit in an
enclosed area, such as a closed cabinet. Allowance of at least 5 inches (127mm) of space between the
back and sides of the appliance are suggested, which allows the proper air circulation to cool the
compressor and condenser.
ELECTRICAL CONNECTION
WARNING: Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by a qualified electrician or contact Whynter Service Department.
This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground outlet with three-prong.
Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly
grounded. The cord should be secured behind the appliance and not left exposed or dangling to
prevent accidental injury.
The appliance should always be plugged into its own individual electrical outlet which has a voltage
rating that matches the rating label on the appliance. This provides the best performance and also
prevent overloading house wiring circuits that could cause a fire hazard from overheated. Never
unplug the appliance by pulling the power cord. Always grip the plug firmly and pull straight out from
the receptacle. Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.
When moving the appliance, be careful not to damage the power cord.
EXTENSION CORD
Because of potential safety hazards, it is strongly recommended that you do not use an extension
cord with this appliance. However, if you must use an extension cord, it is absolutely necessary that it
be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding type plug and
outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes.
Operation and Controls
To Next Page
Loading...
Need help?
General
