9
Operation and Controls
It is recommended you install the appliance in a place where the ambient temperatures is above 60°F (16°C)
and below 90°F (32°C). If the ambient temperature is above or below recommended temperatures, the per-
formance may be affected. For example, placing your appliance in extreme cold or hot conditions may cause
interior temperatures to fluctuate.
SETTING THE TEMPERATURE
To control the internal temperature, turn the temperature
control dial inside the appliance. The temperature range
is from "0” to “7”, where “7” is the coldest temperature
setting and “0” is the warmest temperature setting.
INTERIOR LIGHT
To turn on/ off the interior light, flip the switch inside the
appliance.
INTERNAL FAN
This beverage refrigerator is equipped with an internal fan
that prevents uneven temperature distribution, ensuring
all of your beverage reaches your desired temperature .
PARTS:
1. Temperature Control
2. Light Switch
3. Interior Light
4. Internal Fan
REVERSING THE DOOR SWING
Tools needed: flathead screwdriver, Phillips screwdriver
CAUTION: Before you begin, unplug the beverage
refrigerator from power.
To remove the door:
1. Using a flathead screw driver carefully pry the top hinge
cover off.
2. Using a Phillips screwdriver, remove the screws and take
off top hinge. Keep the parts together and set them aside.
3. Lift the door off the bottom hinge and set the door aside.
4. Remove the bottom hinge by removing the screws with a
Phillips head screwdriver.
To install the door:
1. Using a flathead screwdriver, remove the plugs and cov-
er from the opposite cabinet top corner and from the door.
Set aside.
2. Install the bottom hinge at the opposite side corner and
fasten the screws.
3. Position the door on the bottom hinge.
4. Align the door on the bottom hinge and install the top
hinge.
5. Push the plugs and covers into the corresponding holes.
To Next Page
Loading...
Need help?
General
