To Next PageTo Next PageWhy is the ice from my Whynter IDC-221SC Ice Maker too large and sticking together?
If the ice made by your Whynter Ice Maker is too large and with pieces sticking together, the water temperature in the storage tray or the ambient temperature might be too low. Stop the unit and reset the ice making cycle. Restart the machine after turning it off.
Why are not all freezing bars making ice in my Whynter IDC-221SC Ice Maker?
If not all freezing bars are making ice in your Whynter Ice Maker, it could be due to: * Insufficient water in the reservoir. Ensure the water is at the MAX level before using the portable unit. * No water in the reservoir. Run the unit for a couple more cycles and all bars should be frozen. * When the unit is first started, refrigerant may not be flowing to all freezing bars. Run the unit for a couple more cycles and all bars should be frozen.
Why is my Whynter Ice Maker not making ice even when conditions are right?
If the conditions for the ice making cycle are right, but no ice is being made in your Whynter Ice Maker, it could be due to refrigerant leaks or a blocked sealed system. Contact Whynter Service Department. Also, the water pressure might not be properly set. The recommended water pressure is 58 PSI.
Process of making ice, including size selection and water level checks.
How to dispense ice and water, including timer adjustments.
Explanation of common operational sounds and their potential causes.
Guidance on actions to take during power outages.
Steps to drain water from the unit for cleaning or storage.
Instructions on how to detach the water inlet hose.
Procedures for cleaning the interior and reservoir for hygiene.
How to clean the unit's outer surfaces.
Steps for defrosting and cleaning the inside of the unit.
General
