Wicked lasers S3 Arctic Series - SmartSwitch 2.0 Codes; Mode Selection Sequences

WICKED LASERS 2010 Pro Series | 11WICKED LASERS 2010 Pro Series | 10
WWW.WICKEDLASERS.COM
SmartSwitch™ 2.0 Codes:
After unlocking your laser, you can select among the active modes
by using one of these following codes when pressing the button:
▪ A long hold (holding down briey for less than a second)
cycles between high power and low power.
▪ A short hold cycles Strobe mode to Continuous Wave mode.
▪ Clicking 3 times within 2 seconds goes into SOS mode.
▪ From SOS mode, one quick press will change it into
Beacon mode.
▪ From Beacon mode, one quick press will change it to low
power Strobe mode.
▪ Holding the switch for 3 seconds will go to Tactical
Hibernation mode. The middle LED will be ashing to
indicate this.
How To Use The SmartSwitch™ 2.0 How To Use The SmartSwitch™ 2.0
Push the Power Button on the
Tailcap to turn on your laser.
The rst LED will start ashing
indicating the laser is ready to
be unlocked.
1
➡
FLASHING
Click (short hold) the
SmartSwitch™ button. After
the rst click the rst LED will
be ON and the second LED
will start ashing.
2
➡
FLASHING
Click (short hold) the button
again. The rst and second
LEDs will be steady and the
third LED will start ashing.
3
➡
FLASHING
Click (short hold) the button
a third time.Both rst and
second LEDs will start ashing.
4
➡
FLASHING
➡
FLASHING