Wicked lasers S3 Arctic Series - SmartSwitch 2.0 Code Illustrations; Code Sequence Diagrams; Using Your Laser; Battery Installation Guide

WICKED LASERS 2010 Pro Series | 13WICKED LASERS 2010 Pro Series | 12
WWW.WICKEDLASERS.COM
How To Use The SmartSwitch™ 2.0
Code sequences should be
performed consecutively
otherwise it will reset if you
pause in between clicking or
holding for too long.
After correctly entering the
code sequence to unlock
the laser, the laser will
automatically be turned ON to
it’s default setting and operate
in low power/strobe mode.
Using Your Laser
At the back of the laser, rotate endcap
counter clockwise to open.
Insert one Li-Ion Type 18650 IMR
rechargeable battery negative (-) end rst.
Push the button located on the tail cap to
operate laser.
NOTE: Do not attempt to use a di󱐯erent battery type for this laser, doing so might damage the laser and void the warranty.
(+)
Hold down (long hold)
the button briey and the
second and third LEDs will
start ashing.
5
Hold down (long hold) the
button briey again and all
three LED’s will ash three
times, then goes into battery
indicator status.
6
➡
FLASHING
➡
FLASHING
➡
FLASHING
➡
FLASHING
➡
FLASHING