WICKED LASERS 2010 Pro Series | 9WICKED LASERS 2010 Pro Series | 8
WWW.WICKEDLASERS.COM
How To Use The SmartSwitch™ 2.0 How To Use The SmartSwitch™ 2.0
The S3 Series are the world’s rst and only
hand held lasers equipped with SmartSwitch™
technology. SmartSwitch™ combines both
safety and intelligence by requiring the user
to follow a protocol of simple clicks and click/
holds to operate the device.
Once unlocked, the laser runs in low power
strobe mode (18Hz strobe) which is the default
setting designed for safety.
The following page is a visual guide on how
to unlock the laser by simply following a few
simple steps. The ashing LEDs indicate if a
step has been correctly followed.
The following 9 modes are enabled by using
the SmartSwitch™ 2.0:
▪ Strobe Mode (Hi / Low)
▪ Continuous Wave (Hi / Low)
▪ SOS (Hi / Low)
▪ Beacon (Hi / Low)
▪ Tactical Hibernation Mode
Once the power is on, the user can toggle between
the dierent active modes all available in low
power and high power: Strobe, Continuous wave,
SOS and Beacon mode with a few simple clicks.
There is also the Tactical hibernation mode which
allows you to shut o the laser and quickly re-
enable it with the last setting it was on.
Unlocking Your Laser: This is the rst code you should remember three short clicks
+ two short holds will let you unlock the laser.
To Next Page
Loading...
Need help?
General